Standard knuckle duster

This is a knuckle duster, that I made recently, together with few others(some already on forum, some will come).

It is made from 11 millimeters thick alluminium block. It's same as you can buy on fairs and simmiliar, but has oval fingerholes and curved fingertops instead of flat tops.

This is a standard one, that you can buy nearly anywhere:

Non-simmetrical alluminium knuckle duster

This knuckle duster is made by me, few weeks ago.

It is made from 10 millimeters thick alluminium and measures 102 x 65 millimeters.

Palmrest is curved, so it fits in hand pretty well(as seen on last picture), but has a small curved guard on left side(if held in right hand) so it has only one way to hoold.

I think, I will make a simmiliar duster with hole in middle soon.

Aluminium knuckle duster with spikes

So this is a new knuckle duster that was made recently...

It is made from 11 millimeters thick alluminium and measures 102 x 60 millimeters.
Palmrest is slightly curved, which gives much much better grip in hand than straight.

It is slightly small for my hand size, but I think, that would still be very usefull.

It has sanded finish, so that's where is that matt color from.

First brass knuckle duster

This is my first knuckle duster, that is made from brass.

It is 12 millimeters thickabout 0.45 inch) and isn't very ordinary style. It has 4 slots for fingers, but only 3 holes (middle is double, obvious lol).

Underneath are another three holes, in shape of X. It is representing word SEX(which was first idea, but about 0.25 seconds later noticed, that wouldn't be readable same from both sides, obvious again lol).

Palmrest is slightly curved, I think it could be more. It fits to my fist good, but I think that palmrest could be a little more curved on further dusters.

It also had four 25° brass spikes on fingertops which are very sharp.

It weights for about 3-4 ordinary alluminium knuckle dusters due the material.